Filter for 3-phase inverter with capacity 22kA

Product Information

The FT330 series is designed based on the frequency domain properties of the inverter's input at the inverter's inlet and on other digital devices. The three-stage filter design uses a special magnetic material to ensure high impedance in the wide frequency range. The frequency converter around the normal operation of electronic devices to address the large interference of inverter interference. 250A on the use of co-routing, with more uniform international design standards, convenient and secure customer connection.

• Good performance of suppressing common mode and differential mode interference, effectively suppress the conducted interference from inverter.
• Various connection ways, terminal block terminals(with or without arcing shield) available
• Suited for working place with strict requirement of environment
• Safety approval：ϹЄ

Manual instruction

Filter guide Filter storage and operating environment Power filters are not exposed or exposed to rain, should be stored in the air, the maximum relative humidity of the air does not exceed the heat. ambient temperature -30 ° C to +65 ° C 90% (air temperature 20 ℃ ± 5 ℃), non-corrosive liquid, storage gas.

Filter settings:

Filter installation location should be selected at the source entrance, shortening the length of the line into the frame, reducing the radiation interference. Filter the input and output lines: neither cross nor tie. The filter housing must be grounded in a large area, the ground wire should be as short as possible when connected to other equipment. If the output of the filter is a bolt, the user must use two bolts to tighten the nut when wiring to avoid internal line changes due to bolt rotation caused by short circuit and reduce FEng effect. The snake screw when first using the refusal of an early stage of the widow, then wrench the nut with a wrench - otherwise it could damage the XB Terminal filter - another drag.

Weight: 3600g

Product size: